A Digital Mode-Matching Control System Based on Feedback Calibration for a MEMS Gyroscope
A digital mode-matching control system based on feedback calibration, where two pilot tones are applied to actuate the sense mode by the robust feedback controller, is presented for a MEMS gyroscope in this paper. A dual-mass decoupled MEMS gyroscope with the integrated electrostatic frequency tunin...
| Main Authors: | , , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Hindawi Limited
2019-01-01
|
| Series: | Journal of Sensors |
| Online Access: | http://dx.doi.org/10.1155/2019/9894367 |
| Summary: | A digital mode-matching control system based on feedback calibration, where two pilot tones are applied to actuate the sense mode by the robust feedback controller, is presented for a MEMS gyroscope in this paper. A dual-mass decoupled MEMS gyroscope with the integrated electrostatic frequency tuning mechanisms, the quadrature correction electrode, and the feedback electrode is adopted to implement mode-matching control. Compared with the previous mode-matching method of forward excitation calibration, the proposed mode-matching scheme based on feedback calibration has better adaptability to the variation in the frequency of calibration pilot tones and the quality factor of the sense mode. The influences of calibration pilot tone frequency and the amplitude ratio on tuning performance are studied in theory and simulation. The simulation results demonstrate that the tuning error due to the amplitude asymmetry of the sense mode increases with a frequency split between pilot tones and the drive mode and is significantly reduced by the amplitude correction technology of pilot tones. In addition, the influence of key parameters on the stability of the mode-matching system is deduced by using the average analysis method. The MATLAB simulation of the mode-matching control system illustrates that simulation results have a good consistency with theoretical analysis, which verifies the effectiveness of the closed-loop mode-matching control system. The entire mode-matching control system based on a FPGA device is implemented combined with a closed-loop self-excitation drive, closed-loop force feedback control, and quadrature error correction control. Experimental results demonstrate that the mode-matching prototype has a bias instability of 0.63°/h and ARW of 0.0056°/h1/2. Compared with the mode-mismatched MEMS gyroscope, the performances of bias instability and ARW are improved by 3.81 times and 4.20 times, respectively. |
|---|---|
| ISSN: | 1687-725X 1687-7268 |