Conduction band offset-dependent induced threshold voltage shifts in a-InGaZnO TFTs under positive bias illumination stress

In this paper, the dependence of threshold voltage (Vth) changes to amorphous-indium gallium zinc oxide (a-IGZO) thin film transistors (TFTs) under positive bias light illumination (PBIS) on the height of the conduction band offset was studied. Using SiO2, HfO2, and Al2O3 as gate dielectrics, three...

Full description

Bibliographic Details
Main Authors: Hyojung Kim, Soonkon Kim, Jongmin Yoo, Changyong Oh, Bosung Kim, Hyuncheol Hwang, Jungmin Park, Pyungho Choi, Jangkun Song, Kiju Im, Byoungdeog Choi
Format: Article
Language:English
Published: AIP Publishing LLC 2021-03-01
Series:AIP Advances
Online Access:http://dx.doi.org/10.1063/5.0035379
Description
Summary:In this paper, the dependence of threshold voltage (Vth) changes to amorphous-indium gallium zinc oxide (a-IGZO) thin film transistors (TFTs) under positive bias light illumination (PBIS) on the height of the conduction band offset was studied. Using SiO2, HfO2, and Al2O3 as gate dielectrics, three different types of a-IGZO TFTs were used in the experiment. Electrical parameters and the density of states of each TFT were measured. Of the devices studied, the interface characteristics between the a-IGZO and the gate dielectric were the best using SiO2 and the worst using Al2O3. HfO2 had the smallest conduction band offsets (CBO) of 2.26 eV. We also performed PBS and PBIS evaluation to confirm the stability of TFTs. The Vth shift in the three samples was insignificant under PBS, but the Vth shifts occurred under PBIS in the order of HfO2, Al2O3, and SiO2. The interfacial characteristics of a-IGZO and the dielectric did not change after PBIS in all three devices; the lower the CBO height, the greater the Vth shift after PBIS. The predominant cause of the Vth shift under PBIS is the accumulation of injected photoelectrons that have sufficient energy to tunnel the CBO barrier into the gate dielectric by positive gate bias.
ISSN:2158-3226