Modification and Performance Evaluation of a Mono-valve Engine
AN ABSTRACT OF THE THESIS OF Justin W. Behrens, for the Master of Science degree in Mechanical Engineering, presented on June 24, 2011 at Southern Illinois University Carbondale. TITLE: MODIFICATION AND PERFORMANCE EVALUATION OF A MONO-VALVE ENGINE MAJOR PROFESSOR: Dr. Suri Rajan A four-stroke eng...
| Main Author: | |
|---|---|
| Format: | Others |
| Published: |
OpenSIUC
2011
|
| Subjects: | |
| Online Access: | https://opensiuc.lib.siu.edu/theses/638 https://opensiuc.lib.siu.edu/cgi/viewcontent.cgi?article=1645&context=theses |
| Summary: | AN ABSTRACT OF THE THESIS OF Justin W. Behrens, for the Master of Science degree in Mechanical Engineering, presented on June 24, 2011 at Southern Illinois University Carbondale. TITLE: MODIFICATION AND PERFORMANCE EVALUATION OF A MONO-VALVE ENGINE MAJOR PROFESSOR: Dr. Suri Rajan A four-stroke engine utilizing one tappet valve for both the intake and exhaust gas exchange processes has been built and evaluated. The engine operates under its own power, but has a reduced power capacity than the conventional 2-valve engine. The reduction in power is traced to higher than expected amounts of exhaust gases flowing back into the intake system. Design changes to the cylinder head will fix the back flow problems, but the future capacity of mono-valve engine technology cannot be estimated. The back flow of exhaust gases increases the exhaust gas recirculation (EGR) rate and deteriorates combustion. Intake pressure data shows the mono-valve engine requires an advanced intake valve closing (IVC) time to prevent back flow of charge air. A single actuation camshaft with advanced IVC was tested in the mono-valve engine, and was found to improve exhaust scavenging at TDC and nearly eliminated all charge air back flow at IVC. The optimum IVC timing is shown to be approximately 30 crank angle degrees after BDC. The mono-valve cylinder head utilizes a rotary valve positioned above the tappet valve. The open spaces inside the rotary valve and between the rotary valve and tappet valve represent a common volume that needs to be reduced in order to reduce the base EGR rate. Multiple rotary valve configurations were tested, and the size of the common volume was found to have no effect on back flow but a direct effect on the EGR rate and engine performance. The position of the rotary valve with respect to crank angle has a direct effect on the scavenging process. Optimum scavenging occurs when the intake port is opened just after TDC. |
|---|