| Summary: | This dissertation focuses on the application of tomography in the sugar milling process, specifically
within the vacuum pan. The research aims to improve the efficiency and throughput of a sugar mill by
producing real-time images of the boiling dynamic in the pan and hence can be used as a diagnostic
tool. The real-time tomography system is a combination of ruggedized data collecting hardware, a
switching circuit and software algorithms. The system described in this dissertation uses 16 electrodes
and estimates images based on the distinct differences in conductivities to be found in the vacuum
pan, i.e. a conductive syrup-like fluid (massecuite) and bubbles.
There is a direct correlation between the bubbles produced during the boiling process and heat transfer
in the pan. From this correlation one can determine how well the pan is operating. The system has
been developed in order to monitor specific parts of a pan for optimal boiling. A binary reconstructed
image identifies either massecuite or water vapour.
Each image is reconstructed using a modified neighbourhood data collection method and a back
projection algorithm. The data collection and image reconstruction take place simultaneously, making
it possible to generate images in real-time. Each image frame is reconstructed at approximately 1.1
frames per second. Most of the system was developed in LabVIEW, with some added external drive
electronics, and functions seamlessly. The tomography system is LAN enabled hence measurements
are initiated through a remote PC on the same network and the reconstructed images are streamed to
the user.
The laboratory results demonstrate that it is possible to generate tomographic images from bubbles vs
massecuite, tap water and deionized water in real-time. === Thesis (M.Sc.Eng.)-University of KwaZulu-Natal, Durban, 2012.
|
|---|
