| Summary: | Electrical engineers have responded to the increasing demand for circuit speed and functionality by reducing transistor feature size and increasing on-chip transistor density. Consequently, interconnect density, both on-chip and the system level is also increasing. Increasing circuit speed translates into shorter clock cycles and signals with faster edge rates, which have multi-GHz bandwidth. Densely packed parallel interconnects will cause signal integrity problems not only due to the increase in crosstalk noise but also due to the intrinsic low pass filter characteristics of the interconnects. The lossy nature of the interconnects is also going to increase due to metal surface roughness at higher frequencies, which will further degrade the signal quality at the receiver input. Embedded Patterned Layer (EPL), which is a patterned floating metal layer between a signal trace and its return path shows promise in reducing far-end crosstalk (FEXT). EPL also allows designers to modify the characteristic impedance of interconnects by varying the different physical parameters of the EPL. This dissertation analyzes the effect of EPL on conductor backed coplanar waveguides (CB-CPW). CB-CPWs excite higher order modes at high frequencies, so work was done to understand the effect of different ground via fence parameters in suppressing the higher modes which helps increase the interconnect bandwidth. A CB-CPW with ground via fence is called a grounded coplanar waveguide (GCPW). A very basic lumped element model transmission line model was developed to account for the effect of floating metals near a transmission line. This model was then used to explain the effect of EPL on a GCPW with large bandwidth. EPL reduces the characteristic impedance of the transmission line. Engineers can then design narrow high impedance transmission lines and use EPL to reduce the impedance to a desired value. This also allows reduction in crosstalk by increasing the spacing between the transmission lines. The EPL also reduced the differential impedance of a grounded conductor backed edge coupled coplanar waveguide, when it was used for differential signaling. Care must be taken to make sure that the EPL is symmetric to both the legs of the differential pair to avoid differential to common mode energy conversion, which can cause electromagnetic interference (EMI) problems. EPL reduced FEXT while increasing near-end crosstalk (NEXT), when the coupled transmission line system was used for single ended signaling. Finally, a statistical method for modeling transmission line metal surface roughness in three dimensional (3D) full wave electromagnetic solvers was developed to account for increased attenuation in transmission lines, at high frequencies, due to metal surface roughness.
|
|---|
