| Summary: | This project was worked on during the autumn 2005 at the Norwegian University of Science and Technology, Department of Electronics and Telecommunications. The assignment was to write a new LabVIEW programme that is to run the measurement procedure of a laser probe setup. The setup is used in characterization of surface acoustic waves(SAW). A programme was written that contained the necessary functionality and proved to operate satisfactorily. Several measurements were made on a SAW transducer, accurately picturing the wave. Fourier analysis were performed on the collected data in order to separate the propagation directions. An absolute amplitude measurement was made on a heterodyne interferometer, and the result was compared to a similar scan made using the laser probe. The work shows that the setup is ready for calibration against the heterodyne interferometer, in order to enable the laser probe to measure absolute amplitude by itself.
|
|---|
