| Summary: | 碩士 === 國立成功大學 === 工程科學系碩士在職專班 === 107 === This research employs the finite element analysis software ANSYS to study the behavior in equipment manufacturing process, and mainly focuses on the comparison between the results of ANSYS simulation and actual experimental data. This research contains two parts, the first part is to use the universal testing machine to conduct three-point bending test on the extra thin QFN electronic packages to obtain the data of the ultimate load and deformation. Next, load the related data to ANSYS, set related conditions to proceed the analysis, observe the deformation corresponding to real situation, and adjust the extra thin QFN electronic package geometry model. The second part is to add the boundary conditions of feed module separator and use ANSYS to simulate the current manufacturing process. Next, determine stress distribution of the defective products under the assumption that the extra thin QFN electronic packages hit the limited block with the flat side and with the sharp point. This thesis considers two improvement plans, plan 1 is to change the material of limited block to have better shock absorbency; plan 2 is to slow down the extra thin QFN electronic packages before it hits the limited block to reduce the shock. The final result shows that the defective rate lowers from 33 pieces to 5 pieces defected per million. The quality of the extra thin QFN electronic packages in feed module separator is greatly improved.
|
|---|
