Design of Miniaturized Printed Circuit Board Antennas for 802.11n MIMO Applications

• Main Authors: Mei Tien, 田玫
• Other Authors: Lih-Tyng Hwang
• Format: Others
• Language: zh-TW
• Published: 2011
• Online Access: http://ndltd.ncl.edu.tw/handle/24963313888392174251

碩士 === 國立中山大學 === 通訊工程研究所 === 99 === In rapid wireless communication technology development environment, antennas, the interface among many wireless communications, are an indispensable component for wireless systems. Miniaturization and functionality stability (high tolerance to environmental variations) of the antenna are fast becoming the design trends in research and development of wireless communication systems. They are also the main objectives of this thesis. In the first part of this thesis, we designed two highly stable antennas, which can be used in notebook computers or tablet PCs. The antenna has self-balanced characteristics, where the environmental interference is minimized, in its performance/functionality and patterns. The first antenna design, which can be easily integrated into an RF front-end board, employed capacitive coupling, differential feed printed loop configurations. Comparing to the existing differentially fed antenna design, our designs are much more miniaturized: the antenna size was 13 mm × 27 mm, the ground size was 4.5 mm × 4.5 mm. Implemented on a low-cost FR4 board, the antenna reduced the leakage current formed on coaxial transmission line, due to the advantage of being differentially fed. The second antenna design, fed by coaxial cable (single-ended fed), and without a ground plane, excited only self-balanced modes. The radiation patterns of higher modes in this antenna design are complete and without side lobes. This antenna design also has wide bandwidth characteristics: at 2.4 GHz it had 380 MHz, and at 5.2 GHz it had 1270 MHz bandwidths of high tolerance (stability). The actual measurement validated our simulation results. In the second part, MIMO antennas were designed for 802.11n wireless standards with maximum transfer rates of up to 300 Mbps. First, we designed two small single antennas, which were applied later in MIMO antenna designs. The size of our MIMO antenna designs was only 19 mm × 30.3 mm. In MIMO antenna designs, we employed two methods to increase the isolation between the two MIMO antennas: one manipulated the ground plane size, in which the isolation reached 18.9 dB; the other utilized a decoupling metal, where the overall isolation reached 24.6 dB in all of the operating frequencies, with the best isolation being 31.4 dB. The frequency of the coupling/decoupling for the decoupling metal can be adjusted independently; thus not affecting the original resonant frequency and the return loss of the two MIMO antennas. Actual measurements conducted in the microwave chamber (Reverberation Chamber) have verified the channel capacity were effectively increased, the total radiation efficiencies were about 60%, and the effective diversity gain was about 7dB. The MIMO antenna designs can practically and easily applied in the USB dongles.