The reduction of drag of two-dimensional blunt-based bodies by blowing

The reduction of drag of two-dimensional blunt-based bodies by blowing

Show other versions (1)

Bibliographic Details
Main Author:	Bertels, Augustinus-Wilhelmus Maria
Published:	2013
Online Access:	http://hdl.handle.net/1993/15521

Similar Items

The reduction of drag of two-dimensional blunt-based bodies by blowing
by: Bertels, Augustinus-Wilhelmus Maria
Published: (2013)

Effects of Heat Addition on Wave Drag Reduction of a Spiked Blunt Body
by: Hongyu Wang, et al.
Published: (2021-01-01)

Hypersonic Flow Field Reconfiguration and Drag Reduction of Blunt Body with Spikes and Sideward Jets
by: Guilai Han, et al.
Published: (2018-01-01)

Linear feedback control for form-drag reduction on bluff bodies with a blunt trailing edge
by: Dahan, Jeremy
Published: (2013)

Quantitative Analysis of Drag Reduction Methods for Blunt Shaped Automobiles
by: Ferenc Szodrai
Published: (2020-06-01)

Effect of End-Plate Tabs on Drag Reduction of a 3D Bluff Body with a Blunt Base
by: Pinn, Jarred Michael
Published: (2012)

Blowing-only opposition control: Characteristics of turbulent drag reduction and implementation by deep learning
by: Zexiang Li, et al.
Published: (2021-03-01)

Effect of blowing flow control and front geometry towards the reduction of aerodynamic drag on vehicle models
by: Tarakka Rustan, et al.
Published: (2019-01-01)

Feedback control of three-dimensional bluff body wakes for efficient drag reduction
by: Brackston, Rowan
Published: (2017)

Numerical Investigation on Drag Reduction and Two-Dimensional Turbulence in Diluted Polymer Solutions
by: Xiong, Yong-Liang
Published: (2010)

Nose micro-blowing for asymmetric vortices control on blunt-nose slender body at high angle of attack
by: Lei Wang, et al.
Published: (2017-11-01)

A method for drag reduction on bluff bodies
by: Lesage, François
Published: (2010)

The Effect of the Hypersonic Bodies with Aerospikes on Drag Reduction
by: Chin-Min Liu, et al.
Published: (2016)

The Near Wake of a Two-Dimensional Hypersonic Blunt Body with Mass Addition
by: Collins, Donald James
Published: (1969)

Distributed Forcing on a 3D Bluff Body with a Blunt Base, An Experimental Active Drag Control Approach
by: Erlhoff, Ethan Bruce
Published: (2012)

Drag reduction in Single-and two-phase flow
by: Thwaites, G. R.
Published: (1973)

Frictional drag of two-dimensional electron gases
by: Hill, N. P. R.
Published: (1998)

Aerodynamic drag reduction and flow control of Ahmed body with flaps
by: Jie Tian, et al.
Published: (2017-07-01)

A Simple Passive Device for the Drag Reduction of an Ahmed Body
by: N. A. Siddiqui, et al.
Published: (2021-01-01)

Drag reduction on spherical bodies due to certain additives in water.
by: Kinnier, John W.
Published: (2012)

Active Flow Control Schemes for Bluff Body Drag Reduction
by: Whiteman, Jacob T.
Published: (2016)

Analysis of Aero Dynamic-Heating and Drag of Hypersonic Flows over A 3-D Blunt Body at Angle of Attack
by: Kuan-Yu Chu, et al.
Published: (1995)

Drag and Heat Flux Reduction using Counterflow Jet and Spike - Analysis of their Equivalence for a Blunt Cone Geometry at Mach 8
by: B. John, et al.
Published: (2021-01-01)

Body Blows Six Performances
Published: (2002)

Base drag reduction by external burning.
by: Caswell, Gary Joe.
Published: (2012)

Drag reduction on bluff bodies by the introduction of a wavy stagnation face
by: Darekar, Rupad
Published: (2001)

Ventricular septal perforation after blunt chest trauma due to blows from a fist
by: Arisa Muratsu, et al.
Published: (2016-10-01)

TWO-DIMENSIONAL, HYPERSONIC WINGS OF MAXIMUM LIFT-TO-DRAG RATIO
by: HULL, DAVID GEORGE
Published: (2007)

Drag reduction visual study /
by: Carpenter, Charles Nelson
Published: (1973)

Visual studies in drag reduction /
by: Ramakka, William Richard
Published: (1977)

Advances in Turbulent Drag Reduction
by: Bo Yu, et al.
Published: (2015-02-01)

A study of numerical simulation and available period of drag reduction for submerged body
by: Sheng-Ta Hsu, et al.
Published: (2001)

Drag reduction of bluff bodies by passive control of boundary layer transition and separation
by: Clapperton Surfleet, Ben Lewis
Published: (2016)

Drag of a cylindrical object in a two-dimensional granular environment
by: Kubota Takumi, et al.
Published: (2021-01-01)

An investigation of excrescence drag due to manufacturing defects on two-dimensional surfaces
by: O'Neill, Darren Frances
Published: (2002)

Cavitation Pattern Visualization and Measurement of Lift and Drag for Two-Dimensional Hydrofoils
by: C.W. Liu, et al.
Published: (1999)

Drag Measurements on an Ellipsoidal Body
by: DeMoss, Joshua Andrew
Published: (2014)

Computational Analysis of Turbulent Flow over a Bluff Body with ‎Drag Reduction Devices
by: Adam Abikan, et al.
Published: (2020-12-01)

The Effect of Plasma Actuator Placement on Drag Coefficient Reduction of Ahmed Body as an Aerodynamic Model
by: James Julian, et al.
Published: (2016-02-01)

Design of the Parameters of Generating Micro-bubble module on the Effect of Drag Reduction of Submerged Body
by: Wei-Gang Zhang, et al.
Published: (2007)

Cannot write session to /tmp/vufind_sessions/sess_s5ofkecagvru3csas4bd9l14p2