Soft Switched Multi-Phase Tapped-Boost Converter And Its Control

• Main Author: Mirzaei, Rahmatollah
• Other Authors: Ramanarayanan, V
• Language: en_US
• Published: 2009
• Subjects: Electric Converters; Multi-phase Boost Converters; Interleaved Boost Converters; Switching Modes; Multiphase Boost Converter; Power Converters - Current Sharing; Zero Voltage Switching (ZVS); Zero Current Switching (ZCS); Zero Voltage Transition (ZVT); Digital Control; Electrical Engineering
• Online Access: http://hdl.handle.net/2005/582

Boost dc-to-dc converters have very good source interface properties. The input inductor makes the source current smooth and hence these converters provide very good EMI performance. On account of this good property, the boost converter is also the preferred converter for off-line UPF rectifiers. One of the issues of concern in these converters is the large size of the storage capacitor on the dc link. The boost converter suffers from the disadvantage of discontinuous current injected to the load. The size of the capacitor is therefore large. Further, the ripple current in the capacitor is as much as the load current; hence the ESR specification of the tank capacitor is quite demanding. This is specially so in the emerging application areas of automotive power conversion, where the input voltage is low (typically 12V) and large voltage boost (4 to 5) are desired. The first part of this thesis suggests multi-phase boost converter to overcome the disadvantages of large size storage capacitor in boost converter. Comparison between the specification of single stage and multi-stages is thoroughly examined. Besides the average small signal analysis of N converters in parallel and obtaining an equivalent second order system are discussed. By paralleling the converters the design of closed loop control is a demanding task. To achieve proper current sharing among the stages using current control method is inevitable. Design and implementation of closed loop control of multi-phase boost converter both in analog and digital is the topic of next part of the thesis. Comparison between these two approaches is presented in this part and it will be shown that digital control is more convenient for such a topology on account of the requirement of synchronization, phase shifted operation, current balancing and other desired functions, which will be discussed later in detail. A new direct digital control method, which is simple and fast, is developed. Two different realizations with DSP controller and FPGA controller are considered. In the last part of the thesis a novel soft switching circuit for boost converter is presented. It provides Zero Voltage Switching (ZVS) for the main switch and Zero Current Switching (ZCS) for the auxiliary switch. The paper presents the idealized analysis giving all the circuit intervals and the equations necessary for the design of such a circuit. The proposed soft switching circuit is particularly suited for the tapped-inductor boost circuit with a minimum number of extra components. Extension of the method to tapped inductor boost converter addresses the application of Zero Voltage Transition (ZVT) to high conversion ratio converters. Extension of the method to multiphase boost converter shows that with less number of auxiliary switches soft switching operation can be achieved for all interleaved switching devices. Several laboratory prototype boost converters have been built to confirm the theoretical results and design methods are matching with both simulation and experimental results.