The use of the fluid mapper in an investigation of flow into symmetrical openings obstructed by plane surfaces

The use of the fluid mapper in an investigation of flow into symmetrical openings obstructed by plane surfaces

Bibliographic Details
Main Author:	Clem, Joseph Dickerson
Published:	Georgia Institute of Technology 2008
Subjects:	Exhaust systems Air flow
Online Access:	http://hdl.handle.net/1853/19655

Similar Items

A study of the flow of air into plane obstructed openings
by: Thomas, Frank Almerine
Published: (2008)

Numerical Studies of Flow and AssociatedLosses in the Exhaust Port of a Diesel Engine
by: Wang, Yue
Published: (2013)

Utilizing Exhaust Valve Opening Modulation for Fast Warm-up of Exhaust After-treatment Systems on Highway Diesel Vehicles
by: Hasan Üstün Başaran
Published: (2020-03-01)

Free surface air entrainment and single-bubble movement in supercritical open-channel flow
by: Wei, W., et al.
Published: (2020)

An Investigation of the Composition of the Flow in and out of a Two-Stroke Diesel Engine and Air Consumption Ratio
by: Mirko Grljušić, et al.
Published: (2017-06-01)

The influence of traffic flow factors on automobile exhaust emissions
by: Beard, Louin Lester, 1936-
Published: (1967)

Mathematical modeling of air pollution in city tunnels and evaluating mitigation strategies
by: M.N. Smirnova, et al.
Published: (2020-03-01)

Numerical optimization of flow noises for mufflers based on the improved BP neural network
by: Xiao-lin Xie, et al.
Published: (2016-06-01)

Verification and Comparison of Nine Exhaust Gas Recirculation Mass Flow Rate Estimation Methods
by: Ádám Nyerges, et al.
Published: (2020-12-01)

An Intrinsically Pressure Insensitive Low Cost Particle Number Diluter Featuring Flow Monitoring
by: Markus Bainschab, et al.
Published: (2018-12-01)

Numerical Investigation of MHD Pulsatile Flow of Micropolar Fluid in a Channel with Symmetrically Constricted Walls
by: Amjad Ali, et al.
Published: (2021-04-01)

An experimental investigation of air flow rates at elevated temperature through fittings that are typical of the plumbing in baro-instrumentation
by: Ray, Claude Gable
Published: (2006)

Utilization of Window System as Exhaust Air Heat Recovery Device and Its Energy Performance Evaluation: A Comparative Study
by: Guo, J., et al.
Published: (2022)

AN INVESTIGATION OF INNOVATIVE TECHNOLOGIES FOR REDUCTION OF JET NOISE IN MEDIUM AND HIGH BYPASS RATIO TURBOFAN ENGINES
by: CALLENDER, WILLIAM BRYAN
Published: (2004)

Air flow investigations in direct type solar food dryer using computational fluid dynamics
by: Pankaj K. Gupta
Published: (2016-06-01)

Steady Flow in a Symmetric Thin Liquid Film on an Inclined Surface
by: Joseph Abdul-Ahad, et al.
Published: (2005-12-01)

An experimental investigation of air flow through insulated tubing as a function of approach temperature, pressure ratio, length, and diameter
by: Bradley, Richard Gordon
Published: (2006)

Increase of Ship Power Plants Gas-Air Cooler Efficiency
by: Dymo B.V., et al.
Published: (2017-08-01)

Research on the efficiency of side exhausters
by: Ina Tetsman, et al.
Published: (2010-08-01)

Effects of air intake pressure to the fuel economy and exhaust emissions on a small SI engine
by: Abdullah, N.R, et al.
Published: (2013)

Investigation and modification of secondary air flow on the University of Arizona combustion tunnel
by: Pyle, Edmund Buckman, 1940-
Published: (1964)

Numerical Simulation on Flow Dynamics and Pressure Variation in Porous Ceramic Filter
by: Kazuhiro Yamamoto, et al.
Published: (2018-09-01)

Influence of Fluidic Control in a Staged Lean Jet Engine Burner on Combustor Performance
by: Seiji Yoshida, et al.
Published: (2019-11-01)

An experimental investigation of the flow in wide-angle screened diffusers
by: Lane, D. L.
Published: (1986)

Turbulent flow in concentric and eccentric annuli
by: Denton, John Douglas
Published: (2011)

Symmetric and Non-Symmetric Flows of Burgers’ Fluids through Porous Media between Parallel Plates
by: Constantin Fetecau, et al.
Published: (2021-06-01)

Experimental determination of the respiratory tract deposition of diesel combustion particles in patients with chronic obstructive pulmonary disease
by: Löndahl Jakob, et al.
Published: (2012-07-01)

Measured and derived data at the exhaust of a batch industrial dryer
by: Gianluca Valenti, et al.
Published: (2020-10-01)

Center-Line Velocity Change Regime in a Parallel-Flow Square Exhaust Hood
by: Jianwu Chen, et al.
Published: (2020-06-01)

Specific Features of Calculating the Radiant Component of the Heat Flow of Horizontal Bunch from Finned Tubes with Exhaust Shaft
by: A. B. Sukhotski, et al.
Published: (2020-08-01)

Flows of Dehaven Fluid in Symmetrically Curved Capillary Fissures and Tubes
by: Walicka A., et al.
Published: (2018-05-01)

Pengaruh Air Fuel Ratio Terhadap Emisi Gas Buang Berbahan Bakar Lpg Pada Ruang Bakar Model Helle-Shaw Cell
by: I Gusti Ngurah Putu Tenaya, et al.
Published: (2012-11-01)

Prenatal and early-life diesel exhaust exposure causes autism-like behavioral changes in mice
by: Yu-Chi Chang, et al.
Published: (2018-04-01)

REVERSIBLE VENTILATION SYSTEM FOR ADMINISTRATIVE BUILDINGS
by: Valery Yu. Kravchuk, et al.
Published: (2018-03-01)

Effects of air intake pressure on the engine performance, fuel economy and exhaust emissions of a small gasoline engine
by: Abdullah, N.R, et al.
Published: (2014)

Incompressible flow past a two-dimensional bluff membrane
by: Low, Hong-Tong.
Published: (1980)

The determination of coefficients of discharge and flow equations for air flow through some particular AN standard fittings at elevated temperatures considering pressure ratio as the only influence fo
by: Bennett, John Allen
Published: (2006)

A functionally-analytic method for modelling axial-symmetric flows of ideal fluid
by: Plaksa Sergiy A.
Published: (2019-05-01)

Thermo-Fluid Dynamics Analysis of Fire Smoke Dispersion and Control Strategy in Buildings
by: Ricardo S. Gomez, et al.
Published: (2020-11-01)

Experiments on Turbulence Intensity and Bubble Frequency in Self-Aerated Open Channel Flows
by: Ruidi Bai, et al.
Published: (2018-09-01)