Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions

Measurements of radiated noise and wall pressure fluctuations in a turbulent boundary layer in water are described. A comparison is made between measurements in pure water and in dilute solutions of high molecular weight polymers. To obtain these measurements, a new experimental geometry was de...

Full description

Bibliographic Details
Main Author: Barker, Steven Joseph
Format: Others
Published: 1972
Online Access:https://thesis.library.caltech.edu/6032/1/Barker_sj_1972.pdf
Barker, Steven Joseph (1972) Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions. Dissertation (Ph.D.), California Institute of Technology. doi:10.7907/4TVJ-YA39. https://resolver.caltech.edu/CaltechTHESIS:09152010-105211344 <https://resolver.caltech.edu/CaltechTHESIS:09152010-105211344>
id ndltd-CALTECH-oai-thesis.library.caltech.edu-6032
record_format oai_dc
spelling ndltd-CALTECH-oai-thesis.library.caltech.edu-60322019-12-22T03:09:14Z Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions Barker, Steven Joseph Measurements of radiated noise and wall pressure fluctuations in a turbulent boundary layer in water are described. A comparison is made between measurements in pure water and in dilute solutions of high molecular weight polymers. To obtain these measurements, a new experimental geometry was developed. The principle of the experiment is as follows: A flat steel plate 205 cm long by 80 cm wide is rolled into a single-turn spiral, with a radial gap of 4.5 cm between the two overlapping ends. The spiral is submerged in water and rotated about its axis, creating a boundary layer on the inner surface which leaves the interior of the spiral through the radial gap. The fluid leaving the interior through the gap is replaced through the two open ends of the spiral by means of stationary honeycomb filters which remove residual turbulence and vorticity. Measurements of the mean velocity profile show that the turbulent boundary layer on the inside surface of the spiral resembles that on a flat plate in a uniform free stream. A Reynolds number based upon plate length of 5 x 10^6 is obtained. Wall pressure fluctuations under the boundary layer are measured with piezoelectric transducers mounted flush in the wall of the spiral. Radiated noise is measured with a stationary transducer located outside of the boundary layer, near the center of the spiral. It is shown that the polymer additives cause significant reductions in both the radiated noise and wall pressure spectra. The reductions are greatest at high frequencies, or at Strouhal numbers greater than one. 1972 Thesis NonPeerReviewed application/pdf https://thesis.library.caltech.edu/6032/1/Barker_sj_1972.pdf https://resolver.caltech.edu/CaltechTHESIS:09152010-105211344 Barker, Steven Joseph (1972) Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions. Dissertation (Ph.D.), California Institute of Technology. doi:10.7907/4TVJ-YA39. https://resolver.caltech.edu/CaltechTHESIS:09152010-105211344 <https://resolver.caltech.edu/CaltechTHESIS:09152010-105211344> https://thesis.library.caltech.edu/6032/
collection NDLTD
format Others
sources NDLTD
description Measurements of radiated noise and wall pressure fluctuations in a turbulent boundary layer in water are described. A comparison is made between measurements in pure water and in dilute solutions of high molecular weight polymers. To obtain these measurements, a new experimental geometry was developed. The principle of the experiment is as follows: A flat steel plate 205 cm long by 80 cm wide is rolled into a single-turn spiral, with a radial gap of 4.5 cm between the two overlapping ends. The spiral is submerged in water and rotated about its axis, creating a boundary layer on the inner surface which leaves the interior of the spiral through the radial gap. The fluid leaving the interior through the gap is replaced through the two open ends of the spiral by means of stationary honeycomb filters which remove residual turbulence and vorticity. Measurements of the mean velocity profile show that the turbulent boundary layer on the inside surface of the spiral resembles that on a flat plate in a uniform free stream. A Reynolds number based upon plate length of 5 x 10^6 is obtained. Wall pressure fluctuations under the boundary layer are measured with piezoelectric transducers mounted flush in the wall of the spiral. Radiated noise is measured with a stationary transducer located outside of the boundary layer, near the center of the spiral. It is shown that the polymer additives cause significant reductions in both the radiated noise and wall pressure spectra. The reductions are greatest at high frequencies, or at Strouhal numbers greater than one.
author Barker, Steven Joseph
spellingShingle Barker, Steven Joseph
Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions
author_facet Barker, Steven Joseph
author_sort Barker, Steven Joseph
title Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions
title_short Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions
title_full Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions
title_fullStr Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions
title_full_unstemmed Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions
title_sort radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions
publishDate 1972
url https://thesis.library.caltech.edu/6032/1/Barker_sj_1972.pdf
Barker, Steven Joseph (1972) Radiated noise and wall pressure measurements in turbulent boundary layers in dilute polymer solutions. Dissertation (Ph.D.), California Institute of Technology. doi:10.7907/4TVJ-YA39. https://resolver.caltech.edu/CaltechTHESIS:09152010-105211344 <https://resolver.caltech.edu/CaltechTHESIS:09152010-105211344>
work_keys_str_mv AT barkerstevenjoseph radiatednoiseandwallpressuremeasurementsinturbulentboundarylayersindilutepolymersolutions
_version_ 1719305248124698624