| Summary: | Computational fluid dynamics (CFD) is an effective tool for ship resistance prediction and hull form optimization. A three-dimensional volume mesh is essential for CFD simulation, and mesh generation requires much time and effort. Mesh deformation can reduce the time for mesh generation and simulation. The radial basis function (RBF) and inverse distance weighted (IDW) methods are well-known mesh deformation methods. In this study, the two methods are compared and a novel mesh deformation method for hull form optimization is proposed. For the comparison, a circular cylinder polyhedral mesh was deformed to the National Advisory Committee for Aeronautics (NACA) 0012 mesh. The results showed that the RBF method is faster than the IDW method, but the deformed mesh quality using the IDW method is better than that using the RBF method. Thus, the RBF method was modified to improve the deformed mesh quality. The centroids of the boundary layer cells were added to the control points, and the displacements of the centroids were calculated using the IDW method. The cells far from the ship were aligned to the free surface to minimize the numerical diffusion of the volume of fluid function. Therefore, the deformable region was limited by the deformed boundary, which reduced the time required for mesh deformation. To validate its applicability, the proposed method was applied for varying the bow shape of Japan Bulk Carrier (JBC). The resistances were calculated with the deformed meshes. The calculation time was reduced to approximately one-third using the result of the initial hull form as the initial condition. Thus, the proposed mesh deformation method is efficient and effective enough for CFD-based hull form optimization.
|
|---|
