Study of unmachined area in intricate machining after rough cut in WEDM
Wire electrical discharge machining (WEDM) is well known process for generating intricate and complex profiles in hard metal matrix composites. But damaged surface layer with poor surface integrity is a major disadvantage of WEDM. Beside poor damaged surface layer, after rough/first cut in WEDM, som...
Main Author: | Kamal Jangra |
---|---|
Format: | Article |
Language: | English |
Published: |
Growing Science
2012-10-01
|
Series: | International Journal of Industrial Engineering Computations |
Subjects: | |
Online Access: | http://www.growingscience.com/ijiec/Vol3/IJIEC_2012_47.pdf |
Similar Items
-
An experimental investigation and statistical modelling for trim cutting operation in WEDM of Nimonic-90
by: Vinod Kumar, et al.
Published: (2015-09-01) -
Influence of machining parameters on surface roughness in WEDM cutting
by: Sergiu Lazăr
Published: (2020-11-01) -
Verification of Fuzzy Inference System for Cutting Speed while WEDM for the Abrasion-Resistant Steel Creusabro by Conventional Statistical Methods
by: Katerina Mouralova, et al.
Published: (2020-01-01) -
Microstructural analysis and multi response optimization of WEDM of Inconel 825 using RSM based desirability approach
by: Kumar Pawan, et al.
Published: (2019-10-01) -
Influence of AISI D2 Workpiece Roughness on Heat Partition and Plasma Channel Radius in the WEDM Process
by: Jun Wang, et al.
Published: (2020-10-01)