Design and Implementation of Multilevel Inverters for Electric Vehicles

• Main Authors: C. Dhanamjayulu, Sanjeevikumar Padmanaban, Vigna K. Ramachandaramurthy, Jens Bo Holm-Nielsen, Frede Blaabjerg
• Format: Article
• Language: English
• Published: IEEE 2021-01-01
• Series: IEEE Access
• Subjects: Multilevel inverter; photovoltaic (PV) system; maximum power point tracking (MPPT); electric vehicles (EV); total harmonic distortion (THD)
• Online Access: https://ieeexplore.ieee.org/document/9303361/

The efficient and compact design of multilevel inverters (MLI) motivates in various applications such as solar PV and electric vehicles (EV). This paper proposes a 53-Level multilevel inverter topology based on a switched capacitor (SC) approach. The number of levels of MLI is designed based on the cascade connection of the number of SC cells. The SC cells are cascaded for implementing 17 and 33 levels of the output voltage. The proposed structure is straightforward and easy to implement for the higher levels. As the number of active switches is less, the driver circuits are reduced. This reduces the device count, cost, and size of the MLI. The solar panels, along with a perturb and observe (P&O) algorithm, provide a stable DC voltage and is boosted over the DC link voltage using a single input and multi-output converter (SIMO). The proposed inverters are tested experimentally under dynamic load variations with sudden load disturbances. This represents an electric vehicle moving on various road conditions. A detailed comparison is made in terms of switches count, gate driver boards, sources count, the number of diodes and capacitor count, and component count factor. For the 17-level, 33-level, and 53-level MLI, simulation results are verified with experimental results, and total harmonic distortion (THD) is observed to be the same and is lower than 5% which is under IEEE standards. A hardware prototype is implemented in the laboratory and verified experimentally under dynamic load variations, whereas the simulations are done in MATLAB/Simulink.