| Summary: | The tenacity of the present study was to develop a material using an economical chemical route, having balance between magnetic and dielectric order parameters for maximum transmittance of electromagnetic waves in order to use them in shielding materials. In this context, Mn-Zn ferrites were prepared using a wet chemical based sol-gel auto-combustion technique. X-ray diffraction confirmed the pure phase formation of samples, while some impurity peaks were also present for the higher value of Mn substitution. Field emission scanning electron microscopy revealed a decrease in grain size with increasing Mn substitution. While energy dispersive X-ray spectroscopy confirmed the elemental composition of pure and Mn substituted samples, the dielectric constant, dielectric loss and tangent loss were decreased with increasing frequency and increasing Mn substitution. The complex electric modulus was found to be a function of frequency and values of complex electric modulus were increased with increasing frequency and Mn substitution. The complex impedance of RC series circuit and RC parallel circuit was also decreased with increasing both the parameters while AC conductivity was increased in the series. Dielectric frequency response was also studied for the prepared samples and the best match was found with expected results. The Nyquist and Cole-Cole plots revealed the semi-conductive behavior at higher frequency and Mn substitution also yielded the same results. The relative stability of the samples to be used as dielectric materials was also studied using Bode and Nichols plots, and a comparatively high gain margin was observed, well suitable for potential applications in electromagnetic shielding. Keywords: Mn substituted ZnFe2O4, Impedance spectroscopy, Dielectric frequency response, Dielectric gain margin
|
|---|
