On Coolant Flow Rate-Cutting Speed Trade-Off for Sustainability in Cryogenic Milling of Ti–6Al–4V

• Main Authors: Asif Iqbal, Guolong Zhao, Hazwani Suhaimi, Malik Muhammad Nauman, Ning He, Juliana Zaini, Wei Zhao
• Format: Article
• Language: English
• Published: MDPI AG 2021-06-01
• Series: Materials
• Subjects: machining; titanium; tool damage; surface roughness; tungsten carbide; cutting energy
• Online Access: https://www.mdpi.com/1996-1944/14/12/3429

Application of cryogenic fluids for efficient heat dissipation is gradually becoming part and parcel of titanium machining. Not much research is done to establish the minimum quantity of a cryogenic fluid required to sustain a machining process with respect to a given material removal rate. This article presents an experimental investigation for quantifying the sustainability of milling a commonly used titanium alloy (Ti–6Al–4V) by varying mass flow rates of two kinds of cryogenic coolants at various levels of cutting speed. The three cooling options tested are dry (no coolant), evaporative cryogenic coolant (liquid nitrogen), and throttle cryogenic coolant (compressed carbon dioxide gas). The milling sustainability is quantified in terms of the following metrics: tool damage, fluid cost, specific cutting energy, work surface roughness, and productivity. Dry milling carried out the at the highest level of cutting speed yielded the worst results regarding tool damage and surface roughness. Likewise, the evaporative coolant applied with the highest flow rate and at the lowest cutting speed was the worst performer with respect to energy consumption. From a holistic perspective, the throttle cryogenic coolant applied at the highest levels of mass flow rate and cutting speed stood out to be the most sustainable option.