Distribution laws and characteristics of mud films at casing–cement interfaces in horizontal wells

• Main Authors: Jun Gu, Shichao Li, Yafang Tian, Gang Li, Xinxin Zhao, Linwei Li, Yu Tang
• Format: Article
• Language: English
• Published: KeAi Communications Co., Ltd. 2020-04-01
• Series: Natural Gas Industry B
• Online Access: http://www.sciencedirect.com/science/article/pii/S2352854020300310

The mud film thickness on the outer surface of casing and its distribution laws are important factors affecting the cementation quality at casing–cement interfaces. So far, however, the distribution laws of mud film thickness on the outer surface of casing at different inclinations and its effect on the interfacial cementing strength have never been reported in literatures. In this paper, the mud film thickness at different parts on the outer surface of simulated casing (steel pipe) was measured at the inclination of 0°, 30°, 60° and 86°, respectively, using the independently designed experimental device. Then, the distribution law of mud film thickness on the outer surface of casing and its effect on the interfacial cementing strength were summarized. And the following research results were obtained. First, when the inclination increases from 0° to 86°, the mud film thickness changes from uniform distribution to thin-and-thick distribution, and the area proportions of thinner and thicker mud films both increase. And especially at the inclination of 86°, the mud film thickness on the upper surface is very large, and there are large exposed areas on the left and right surfaces of the steel pipe. Second, the cementing strength at the casing–cement interface of the exposed casing is much higher than that at the interface with mud film. And with the increase of inclination, the interfacial cementing strength with mud film tends to increase. Third, with the increase of inclination, the interfacial cementing strength increases successively, which is closely related to the area proportion of the exposed steel pipe to the solid mud film on the outer surface. In conclusion, the exposed area of the simulated casing on the outer surface is a key factor affecting its interfacial cementing strength. Keywords: Casing–cement interface, Inclination, Mud film thickness, Distribution law, Cementing strength, Exposed outer surface of casing