| Summary: | Utilizing 3D printing to create custom microwave filters has promising aspects such as light weight and low cost, most importantly including the fact that complicated structures can be printed quickly and inexpensively. Some SLA resins have very high Coefficient of Thermal Expansion (CTE) compared to metal, so SLA 3D printed microwave filters can have frequency responses that are strongly dependent on temperature-a serious problem for narrow band filters. The presented technique overcomes this limitation, and in fact yields an SLA 3D printed filter with better temperature stability than an uncompensated metal 3D printed or a conventionally machined metal filter. Two 3D printed, temperature compensated microwave cavity notch filters have been fabricated using stereolithography (SLA) resins. Both use two different values of CTE for compensation. The 3D printed plastic parts are electroplated with copper. One filter consists of a resonant cavity with the TE<sub>011</sub> mode coupled to a TE<sub>10</sub> waveguide. The other is a TE<sub>101</sub> resonant cavity coupled to TE<sub>10</sub> waveguide. As temperature increases, the side walls of the cavities grow, lowering the resonant frequency. At the same time, for the TE<sub>011</sub> cavity, an end-wall tuning plunger made of stereolithography resin with a higher CTE than the cavity walls expands at a faster rate. The end wall expansion increases the resonant frequency. In the case of the TE<sub>101</sub> cavity, a metallic plunger expands much more slowly than the cavity and effectively withdraws as temperature increases, which increases the resonant frequency.
|
|---|
