Designing the structures of discrete solid­alloy elements for broaching the holes of significant diameter based on the assessment of their strength

• Main Authors: Yakiv Nemyrovskyi, Ihor Shepelenko, Eduard Posviatenko, Yuri Tsekhanov, Sergiy Polotnyak, Sergii Sardak, Valentina Bandura, Yurii Paladiichuk
• Format: Article
• Language: English
• Published: PC Technology Center 2020-06-01
• Series: Eastern-European Journal of Enterprise Technologies
• Subjects: deforming broaching; stressed state; solid alloy; discrete deforming element; element strength
• Online Access: http://journals.uran.ua/eejet/article/view/203524

This paper addresses the issues related to designing and estimating the strength of solid-alloy elements in the deforming broaches of significant diameter (exceeding 150 mm) for the developed process of discrete broaching. The tool limit condition was assessed based on two strength criteria: the specific potential energy of shape change and the maximum tangent stresses. Numerical modeling using the finite element method has made it possible to derive the distribution of equivalent stresses in the tool elements and the contact stresses at the surface of the contact between a solid-alloy insert and the body, which enabled the analysis of tool strength under loading. The simulation was performed under a single normal load, which ensured the versatility of the calculation for any contact pressure values. We have derived formulae to calculate the acceptable contact pressure depending on unit load. The effect of the insert protrusion height over the body on the strength of tool elements has been established. We have derived engineering dependences that determine the required magnitude of insert protrusion over the body depending on the ultimate load. An example of calculating the strength of a prefabricated deforming element in the machining of a sleeve made from gray modified cast iron of hardness HB230 has been considered. Our calculations have shown that the deforming element designed for the new technological process corresponds to the conditions of strength, provided the ratio h1/h=0.15 is maintained (where h1 is the insert height above the body, h is the insert height). The results obtained could be used in engineering calculations when designing the prefabricated tool for discrete deformation, as well as to assess the strength of prefabricated tools, such as cutters, core drills, reamers, when refining external loads