| Summary: | A gas-nitrided layer was produced on the toughened 42CrMo4 low-alloy steel using the changeable nitriding potential in order to limit the thickness of a brittle ε zone. The microstructure consisted of the compound ε + (ε + γ’) zone and diffusion zone (nitric sorbite with γ’ precipitates). Such a layer was subjected to laser heat treatment with or without remelting. The single laser tracks were formed using various laser beam powers (in the range of 0.234–0.624 kW) and scanning rates (in the range of 2.24–3.84 m·min<sup>−1</sup>) and the same laser beam diameter (2 mm). The microstructure of laser-modified nitrided layer usually consisted of re-melted zone (MZ) with coarse-grained nitric martensite Fe<sub>α’</sub> and possible ε precipitates, heat-affected zone (HAZ) with fine-grained nitric martensite Fe<sub>α’</sub> and γ’ precipitates and diffusion zone with nitric sorbite and γ’ precipitates. Sometimes, the compound zone was partially re-melted and an amount of iron nitrides remained in the MZ. Only one laser track was characterized by the different microstructure, consisting of the compound ε + (ε + γ’) zone, HAZ with fine-grained nitric martensite Fe<sub>α’</sub> and γ’ precipitates and diffusion zone with nitric sorbite and γ’ precipitates. This laser track was formed without visible effects of remelting. The effect of temperature distribution during laser heat treatment of gas-nitrided 42CrMo4 steel on the microstructure and mechanical properties was studied. The equations developed by Ashby and Esterling were used in order to determine the temperature distribution along the axis of each laser track. Taking into account the temperature profiles, it was possible to calculate the depths of MZ and HAZ. These predicted values were compared to those-measured based on the microstructure observations, obtaining good compatibility. The microstructure of the produced surface layers influenced the mechanical properties such as hardness and Young’s modulus. The hardness of MZ was higher than that of ε zone and lower than that of ε + γ’ zone when compared to nitrided layer. Whereas Young’s modulus of MZ was significantly higher than those characteristic of the compound zone in gas-nitrided layer (both ε and ε + γ’ zone) and similar to that of HAZ. The laser heat treatment (LHT) without remelting resulted in the similar hardness and slightly higher Young’s modulus of ε zone in comparison with the nitrided layer. Simultaneously, such a treatment of the nitrided layer did not influence the hardness and the Young’s modulus of ε + γ’ zone considerably. The hardness of HAZ was higher than that of MZ and that of the same area of diffusion zone in the nitrided layer because of the presence of fine-grained nitric martensite with γ’ precipitates after laser quenching.
|
|---|
