| Summary: | A biaxial shear test is performed on prefabricated, single-fissure type, cubic rock-like specimens by using the TZW-500 rock direct shear apparatus to study the shear strength characteristics, crack coalescence, and propagation modes of the specimens with different geometric parameters. Results show that the crack coalescence and propagation modes of the rock-like specimens with prefabricated fissures can be divided into four types, namely, single main shear crack coalescence mode, main shear crack coalescence and secondary tensile-shear crack propagation mode, main shear crack coalescence and secondary shear crack propagation mode, and main shear crack coalescence and secondary tensile crack propagation mode. All modes are affected by the dip angle α and length l of the prefabricated fissure. When the dip angle of the prefabricated fissure is α∈[0°, 20°) or (70°, 90°], the cracks center on shear failure, and most shear cracks propagate along one end of the prefabricated fissure. At α∈(30°, 50°), the cracks bear the tensile-shear combined action, and the shear cracks propagate along the two ends of the prefabricated fissure. The peak shear strength of the rock-like specimens with prefabricated fissures is also closely related to the dip angle α and length l of the fissure. With the increase in dip angle α of the prefabricated fissure, the peak shear strength of each rock-like specimen decreases initially then increases, and the peak shear strength curve presents a similar “U” shape. At α∈[30°, 60°], the peak shear strength is within the peak-valley interval. When the length l of the prefabricated fissure is increased, the peak shear strength experiences a gradual reduction. When l > 20 mm, the peak shear strength is greatly influenced by l, but the influence is minimal when l ≥ 20 mm. At the same dip angle α and fissure length of l ≥ 20 mm, the correlation between peak shear strength and fissure width b is low.
|
|---|
