Modification of surface morphology of Ti6Al4V alloy manufactured by Laser Sintering
The paper deals with the evaluation of relation between roughness parameters of Ti6Al4V alloy produced by DMLS and modified by abrasive blasting. There were two types of blasting abrasives that were used – white corundum and Zirblast at three levels of air pressure. The effect of pressure on the val...
| Main Authors: | , , , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
De Gruyter
2016-06-01
|
| Series: | Open Engineering |
| Subjects: | |
| Online Access: | http://www.degruyter.com/view/j/eng.2016.6.issue-1/eng-2016-0020/eng-2016-0020.xml?format=INT |
| Summary: | The paper deals with the evaluation of relation
between roughness parameters of Ti6Al4V alloy produced
by DMLS and modified by abrasive blasting. There were
two types of blasting abrasives that were used – white
corundum and Zirblast at three levels of air pressure. The
effect of pressure on the value of individual roughness parameters
and an influence of blasting media on the parameters
for samples blasted by white corundum and Zirblast
were evaluated by ANOVA. Based on the measured values,
the correlation matrix was set and the standard of correlation
statistic importance between the monitored parameters
was determined from it. The correlation coefficient
was also set. |
|---|---|
| ISSN: | 2391-5439 |