The Changing and Distribution Laws of Oxygen Transfer Efficiency in the Full-Scale IFAS Process

• Main Authors: Xuyang Liu, Xuejun Bi, Qing Huang, Xiaodong Wang, Ruihuan Gu, Xiaolin Zhou
• Format: Article
• Language: English
• Published: MDPI AG 2021-07-01
• Series: Water
• Subjects: integrated fixed-film activated sludge; carrier filling ratio; full-scale; oxygen transfer efficiency; aeration types
• Online Access: https://www.mdpi.com/2073-4441/13/14/1933

The integrated fixed-film activated sludge (IFAS) process has been widely used in the upgrading of wastewater treatment plants (WWTPs). The oxygen transfer efficiency (αOTE) is of great significance to the design and operation of the IFAS process. The carrier filling ratio (CFR) and aeration type are two critical factors affecting αOTE and standard oxygen transfer efficiency (αSOTE). However, the distribution and changing laws of αOTE and αSOTE in the full-scale IFAS process areunclear. To optimize the operation of a WWTP and to improve the αOTE of the aeration systems, several off-gas tests were conducted under different aeration types and different CFRs. The results show that for the aerobic tank investigated (the ratio of length and width was 8:1), the αOTE and the αSOTE of the middle of the aeration systems were higher than those of the other two sides. However, the reason for the low αOTE at the beginning and the end of the tank may be different. Coarse-bubble aeration systems had a lower αOTE and almost the same oxygenation capacity (αSOTE) as the fine-bubble aeration systems under constant CFR (43%). The average αSOTE (18.7–28.9%) of the hybrid aeration systems increased with increasing CFR (7.7–57.7%), and different locations exhibited different degrees of change. The results reveal the distribution and changing law of the αOTE of aeration systems in the IFAS process, and attention should be paid to the improvement of the OTE of the plug-flow IFAS process.