| Summary: | Arsenic (As) and chromate (Cr(VI)) contamination of ground and surface waters is a major problem worldwide. Given that a new drinking water limit is anticipated for Cr(VI) and that the limit of arsenic in drinking water is quite low (10 μg/L), there is an urgent need for evaluating technologies that could be efficient for removal of both contaminants simultaneously. In this work, the use of Fe(II) redox assisted coagulation was investigated to simultaneously remove the contaminants of interest. The basic principle of this technology is that Fe(II) could react with Cr(VI) and form Fe(III)-hydroxides and insoluble Cr(III) species, while the freshly formed Fe(III) hydroxides are very efficient adsorbents for As(V). The effect of pH, the water matrix composition, Fe(II) dose, initial contaminant concentrations, NOM presence and phosphate concentration were the examined parameters. The results revealed that with a dose of 2 mg/L Fe(II), residual As(V) and Cr(VI) concentrations were both below 10 μg/L, from initial concentrations of 50 μg/L. Though, this is effective only at circumneutral pH values. This is however not a big obstacle, since most natural waters, especially groundwaters, have near neutral pH values. At these pH values, residual iron concentration was far below 200 μg/L. The presence of phosphate anions inhibited As(V) removal but had no effect on Cr(VI) removal. Increasing Fe(II) concentrations eliminated the effect of phosphate and provided simultaneous phosphate removal. Therefore, Fe(II) coagulation can be applied, with secured results, for simultaneous As(V), Cr(VI) and phosphate removal from waters.
|
|---|
